Latest [Nov 17, 2021] 100% Passing Guarantee - Brilliant 350-501 Exam Questions PDF
350-501 Certification – Valid Exam Dumps Questions Study Guide! (Updated 250 Questions)
Exam Topics
Cisco 350-501 will validate the professionals’ understanding of applying the core service provider network technologies, such as core architecture, networking, services, automation, quality of services, network assurance, and security. All in all, the overall content consists of 5 subject areas that are listed below:
Architecture: 15%
- Implementing data plane security (RTBH, uRPF, and ACLs).
- Configuring and verifying control plane protection techniques (CoPP and LPTS), BGP prefix suppression, LDP security, and BGP flowspec & sec;
- Describing management plane security;
- Describing service provider virtualization, such as VNF workloads, OpenStack, and NFV infrastructure;
- Describing the core structures (SR, Metro Ethernet, MPLS, and unified MPLS) and mobility (packet core and RAN xhaul transport for 5G & 4G);
- Describing the QoS architecture (MPLS TE QoS, IPv6 flow label, DiffServ & IntServ QoS models, and MPLS QOS models);
- Describing the Cisco network software structure, including IOS XE, IOS, and IOS XR;
NEW QUESTION 91
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION 92
When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not tacking the expected path in the core.
Which command do you use to quickly check path of a TE tunnel?
- A. traceroute <tunnel destination IP>
- B. Ping <tunnel destination IP>
- C. traceroute mpls ipv4 <tunnel destination>
- D. show mpls traffic-engineering tunnels
Answer: C
Explanation:
Section: MPLS and Segment Routing
NEW QUESTION 93
Refer to the exhibit.
A network administrator is implementing IGMP to enable multicast feed transmission to the receiver. Which configuration must the administrator deploy on GW1 to permit IGMP Joins only to the assigned (S, G) feed?
A)
B)
C)
D)
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: A
Explanation:
NEW QUESTION 94
Which two actions describe ISP delegation to PCE servers? (Choose two)
- A. entering the mpls traffic-eng reoptimize command
- B. adding a new PCE server with lower precedence than the primary PCE
- C. changing the precedence of any of the PCE servers
- D. adding a new PCE server with higher precedence than the primary PCE
- E. removing TE re-optimization timer timeouts
Answer: B,E
NEW QUESTION 95
Drag and drop the multicast concepts from the left onto the correct descnpt.ons on the right.
Answer:
Explanation:
NEW QUESTION 96
Refer to the exhibit:
It the NetFlow configuration is updated to version 9, which additional piece of information can be reported"?
- A. IPv4 flow information
- B. flow sequence numbers
- C. BGP AS information
- D. IPv6 flow information
Answer: D
NEW QUESTION 97
Refer to the exhibit.
ASN 64501 currently reaches the networks under the 10.0.0.0/8 prefix via the North_B router, which is a slow backup link. The administrator of ASN 64502 wants traffic from ASN 64501 to 10.0.0.0/8 to travel via the primary link North_A.
Which change to the network configuration accomplishes this task?
- A. Set a Lower Weight value for incoming traffic on North_A
- B. Advertise the 10.0.0.0/8 prefix through North_B and specific subnets through North_A
- C. Set a higher local preference between North_A and South_A
- D. Set a lower MED between North_B and South_B
Answer: D
NEW QUESTION 98
Refer to the exhibit:
What is the URL used for with REST API?
- A. It is used to contact a URL filter to determine the efficacy of a web address
- B. It is used to send a TACACS+ authentication request to a server
- C. It is used to initiate an FTP session to save a running configuration of a device.
- D. It is used to send a message to the APIC to perform an operation on a managed object or class operator
Answer: D
NEW QUESTION 99
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 1 is the trigger router in a RTBH implementation.
- B. Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.
- C. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
- D. Router 2 is the router receiving the DDoS attack
Answer: A
NEW QUESTION 100 
Refer to the exhibit. Which show command should be implemented to display per-interface statistics about uRPF drops and suppressed drops?
- A. show cef interface
- B. show ip interface
- C. show ip interface brief
- D. show ip traffic
Answer: B
Explanation:
Section: Architecture
Explanation/Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_urpf/configuration/xe-3s/sec-data-urpf-xe-3s-book/ cfg-unicast-rpf.html#GUID-3609F224-5D40-422E-8754-B12C60677612
NEW QUESTION 101
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right
Answer:
Explanation:
NEW QUESTION 102
Refer to the exhibit:
Which information is provided for traceback analysis when this configuration is applied?
- A. IP sub flow cache
- B. source interface
- C. BGP version
- D. packet size distribution
Answer: C
NEW QUESTION 103
An engineer implemented LDP protocol on the ISP network. The engineer must ensure that there are no packet loss issues when IGP and LDP protocols are not synchronized. Which configuring must the engineer implement so that the IGP routing protocol will wait until LDP convergence is completed?
- A. Disable MPLS LDP IGP synchronization on the network.
- B. Configure MPLS LDP IGP synchronization on the network.
- C. Configure LDP sessions protection on the network.
- D. Disable IP CEF on routers running LDP and enable LDP protocol.
Answer: B
NEW QUESTION 104
Refer to the exhibit.
Which type of DDoS attack will be mitigated by this configuration?
- A. SIP INVITE flood attacks
- B. teardrop attack
- C. smurf attack
- D. SYN flood
Answer: C
NEW QUESTION 105 
Refer to the exhibit. An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 2 must configure a route to null 0 for network 192.168.1.0/24 for the RTBH implementation to be complete.
- B. Router 1 is the trigger router in a RTBH implementation.
- C. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
- D. Router 2 is the router receiving the DDoS attack.
Answer: D
Explanation:
Section: Architecture
NEW QUESTION 106
Which two IS-IS parameters must match before two Level 2 peers can form an adjacency? (Choose two )
- A. authentication settings
- B. MTU
- C. system ID
- D. area ID
- E. hello timer setting
Answer: A,B
NEW QUESTION 107
Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?
- A. The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN.
- B. The Internet gateway router is connected as a PE router to the MPLS backbone.
- C. The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway.
- D. The CE router supports VRF-Lite and the full BGP routing table.
Answer: C
Explanation:
Section: Architecture
Explanation
NEW QUESTION 108
After implement MPLS protocol for multiple VRFs on a single Cisco device, the engineer notices all VRFs on the router still do to not LDP session protection feature enabled. Which configuration must the engineer apply to enable the LDP session protection feature FOR LDP neighbors within each VRF?
- A. Configure LDP session protection globally on the device and on each neighbor that requires session protection.
- B. Configure LDP session protection within the individual VRFs.
- C. Configure LDP session protection globally on the device only.
- D. Configure LDP session authentication on the device to enable LDP session protection on each VRF automatically.
Answer: B
NEW QUESTION 109
Refer to the exhibit.
Which task completes the configuration?
- A. Specify the activate neighbor 192.168.1.2 under the IPv4 address family.
- B. Specify the source interface in the neighbor statement.
- C. Specify the maximum number of prefixes that R1 receives from neighbor 192.168.1.2.
- D. Specify the local-as value in the neighbor statement.
Answer: A
NEW QUESTION 110
......
350-501 are Available for Instant Access: https://www.dumpstillvalid.com/350-501-prep4sure-review.html
350-501 Dumps 2021 - New Cisco 350-501 Exam Questions: https://drive.google.com/open?id=1VMUEkne2gO5EGKVDHv2FiomrDr6Nm8dD
