Free 350-501 pdf Files With Updated and Accurate Dumps Training
Top-Class 350-501 Question Answers Study Guide
Difficulty in Writing Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies Exam
The Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies certification is one of the most important certifications that applicants can have on their CV. One of the biggest challenges for many candidates is to use the Internet to find so many details that make it impossible for them to believe, which would be beneficial for them to choose the correct materials for their tests.
The Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies test is not simpler and unless well prepared, can prove to be a very tough exam. If competent 350-501 exam dumps are researched and evaluated on 350-501 practice exams, the exam difficulty can be overcome.
However, applicants can clear the examination with the correct concentration and the correct preparatory material. DumpStillValid have the most up to date 350-501 exam dumps pdf that allows a clear understanding of the pattern in questions raised by these dumping aspirants with real certification. The experts track DumpStillValid for all the changes in the course. Certification problems also require realistic research, which is an ideal forum to test the knowledge that is collected. For the study content, refer to the links below.
NEW QUESTION # 232
Refer to the exhibit.
A Cisco engineer is implementing gRPC dial-out on an ASR. Receiver 192.168 1.1 will be assigned one of the subscriptions, and it will manage the ASR. Which command is needed to complete the router configuration?
- A. protocol grpc
- B. protocol tcp
- C. protocol any
- D. protocol all
Answer: B
Explanation:
NEW QUESTION # 233
Refer to the exhibit.
An engineer began to configure LDP between R1 and R2, but R1 and R2 cannot yet establish an LDP TCP connection. Which additional task must be completed to finish the implementation?
- A. Configure the no mpls Idp password option 1 command on R2
- B. Configure the mpls Idp neighbor 172.16.0.1 password command on R1
- C. Configure the mpls Idp neighbor 10.0.12.1 password command on R1
- D. Configure the no mpls Idp password option 1 command on R1
Answer: B
NEW QUESTION # 234
Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?
- A. mode BGP address-family configuration mode
- B. routing configuration mode
- C. BGP neighbor configuration
- D. global configuration mode
Answer: D
NEW QUESTION # 235
Which statement about the overlay VPN model is true?
- A. The overlay model does not scale to the same size as the MPLS VPN model.
- B. The overlay model provides privacy and isolation between the different customers by using packet filters that control the data to and from the customer routers.
- C. The overlay model provides the ability to reduce the amount of routing state that core routers need to hold to meet the scalability requirements compared to the MPLS VPN model.
- D. The overlay model demands a lot from provisioning because when adding one customer site, it demands many configuration changes at many other routers on the provider side.
Answer: C
NEW QUESTION # 236
Refer to the exhibit.
ASN 64501 currently reaches the networks under the 10.0.0.0/8 prefix via the North_B router, which is a slow backup link. The administrator of ASN 64502 wants traffic from ASN 64501 to 10.0.0.0/8 to travel via the primary link North_A.
Which change to the network configuration accomplishes this task?
- A. Set a Lower Weight value for incoming traffic on North_A
- B. Set a higher local preference between North_A and South_A
- C. Set a lower MED between North_B and South_B
- D. Advertise the 10.0.0.0/8 prefix through North_B and specific subnets through North_A
Answer: C
NEW QUESTION # 237
Refer to the exhibit. Users in AS 65010 are connected with the application server in AS 65050 with these requirements:
- AS 65010 users are experiencing latency and congestion to connect
with application server 172.16.50.10.
- AS 65030 must be restricted to become Transient Autonomous System for traffic flow.
- Links connected to AS 65020 and AS 65040 are underutilized and must
be used efficiently for traffic.
Which two configurations must be implemented to meet these requirements? (Choose two.)
- A. Apply the AS-Path route-map policy for traffic received from R3.
- B. Configure the route map to set the MED 50 attribute for R5-R4 BGP peering.
- C. Apply the MED route-map policy for traffic received from R4.
- D. Configure a higher Local preference for R5-R4 BGP peering.
- E. Configure the route map to prepend the AS-Path attribute for R5-R3 BGP peering.
Answer: B,E
NEW QUESTION # 238
Drag and drop the message types from the left onto the target field of the message originator on the right.
Answer:
Explanation:
NEW QUESTION # 239
A network engineer is adding 10Gbps link to an existing 2X1Gbps LACP-based LAG to augment its capacity. Network standards require a bundle interface to be take out of service if one of its member links does down, and the new link must be added with minimal impact to the production network. Drag and drop the tasks that the engineer must perform from the left into the sequence on the right. Not all options are used.
Answer:
Explanation:
NEW QUESTION # 240
Refer to the exhibit.
An engineer is configuring multitiopology IS-IS for IPv6 on router R1. Which additional configuration must be applied to complete the task?
A)
B)
C)
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: A
NEW QUESTION # 241
Refer to the exhibit.
What is the effect of this configuration?
- A. R1 supports a peer that is configured for LDP SSO/NSF as the peer recovers from an outage.
- B. R1 failovers to any peer.
- C. R1 supports a graceful restart operation on the peer, even if graceful restart is disabled on the peer.
- D. R1 failovers only to a peer that is configured for LDP SSO/NSF.
Answer: A
NEW QUESTION # 242
Refer to the exhibit:
Which statement about this configuration is true"?
- A. It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
- B. It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
- C. It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
- D. It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
Answer: A
NEW QUESTION # 243
Refer to the exhibit:
Which statement supports QPPB implementation?
- A. QoS policies use BGP to gain full coverage on the network.
- B. QPPB policies affect only egress traffic
- C. QoS policies rely exclusively on BGP attributes to manipulate traffic
- D. QoS policies are identified in the MPLS forwarding table
Answer: C
NEW QUESTION # 244
Refer to the exhibit.
Refer to the exhibit. In the service provider network, routers PE1, PE2, and PE4 have access to the internet and provide access to customer networks. Router PE3 is used for access to other customer systems. In accordance with a new SLA, an engineer is updating settings on this network so that router CE1 accesses the internet via PE1 instead of PE2. Which two tasks must the engineer perform to complete the process? (Choose two.)
- A. On PE1 and PE4, configure the internet VRF with import route targets 102:102 and 104:104.
- B. On PE1, configure the internet VRF with import route target 102:102.
- C. On PE2 and PE3, configure the internet VRF with import route target 101:101.
- D. On PE2, configure the CE1 VRF with import route target 101:101.
- E. On PE2, configure the internet VRF with import route target 102:102.
Answer: B,D
Explanation:
https://www.cisco.com/c/en/us/support/docs/mpls-vpns/multiprotocol-label-switching-mpls/23986-mpls-vpns-config-example.html
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l3_vpns/configuration/15-mt/mp-l3-vpns-15-mt-book/mp-bgp-mpls-vpns.html
NEW QUESTION # 245
Refer to the exhibit.
Router 4 is added to the network and must be in the same area as router 1. Which NET should the engineer assign?
- A. 49.0011.0000.0000.0003.00
- B. 49.0011.0000.0000.0002.00
- C. 49.0111.0000.0000.0001.00
- D. 49.0001.0000.0000.0004.00
Answer: A
NEW QUESTION # 246
Refer To the exhibit. Which BGP attribute should be manipulated to have CE1 use PE1 as the primary path to the Internet?
- A. The local preference attribute should be manipulated on PE2 on inbound routes advertised to CE1.
- B. The weight attribute should be manipulated on PE1 on outbound routes advertised to CE1.
- C. The MED should be manipulated on CE1 on inbound routes from PE1.
- D. The origin of all routes should be modified on each router on inbound and outbound routes advertised to CE1.
Answer: D
NEW QUESTION # 247
Refer to the exhibit:
A network engineer is implementing an OSPF configuration Based on the output, which statement is true?
- A. OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
- B. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
- C. IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway
- D. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
Answer: A
NEW QUESTION # 248
The network team is planning to implement IPv6 on the company's existing IPv4 network infrastructure. The network currently uses IS-IS to share routes between peers. Which task must the team perform so that IS-IS will run in multitopology mode on the updated IPv6 network?
- A. Configure the network routers as Level 2 routers.
- B. Configure the IS-IS IPv6 metric on the dual-stack links.
- C. Configure the network routers to use metric-style wide.
- D. Configure the links between the network routers as point-to-point.
Answer: B
NEW QUESTION # 249
Which component is similar to an EVPN instance?
- A. router distinguisher
- B. IGP router ID
- C. MPLS label
- D. VRF
Answer: D
Explanation:
Section: Architecture
NEW QUESTION # 250
Refer to the exhibit.
A network engineer is implementing a standard customer route-policy on ASBR1 with these requirements:
* It must accept only customer-assigned prefixes
* It must preserve customer advertised BGP communities
* It must set the local-preference to 110 for all prefixes
* It must attach the ORIGINATION-PE and LOCAL-CITY communities to all accepted prefixes.
Which route policy must the engineer implement on ASBR1 to satisfy the requirements?
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: B
NEW QUESTION # 251
......
Cisco 350-501 certification exam is designed for IT professionals who want to validate their knowledge and skills in implementing and operating Cisco Service Provider Network Core Technologies. 350-501 exam is a part of the Cisco Certified Network Professional (CCNP) Service Provider certification track and is aimed at professionals who are responsible for designing, implementing, and maintaining complex service provider networks.
Real Updated 350-501 Questions & Answers Pass Your Exam Easily: https://www.dumpstillvalid.com/350-501-prep4sure-review.html
Easily To Pass New 350-501 Verified & Correct Answers: https://drive.google.com/open?id=1CcN3TJHfMdLx5iquNJpLwYVqCC61jpV5
