[2023] Pass Juniper JN0-682 Test Practice Test Questions Exam Dumps
Verified JN0-682 dumps Q&As - JN0-682 dumps with Correct Answers
NEW QUESTION # 64
Which statement is true about the route shown in the exhibit?
- A. The route target on this route is 1000
- B. The route is an EVPN type-1 route.
- C. The VNI for this route is 304.
- D. The route uses a type-1 route distinguisher.
Answer: C
NEW QUESTION # 65
In the exhibit, VM1 is part of the same VXLAN segment as VM3.
Which type of message will R1 initially send to R2 so that VM1 receives BUM traffic from VM3?
- A. IGMP Join (*.G)
- B. PIM Register message
- C. PIM Join
- D. IGMP Join (S, G)
Answer: C
NEW QUESTION # 66
You are asked to build a single export policy that can be applied to all devices to advertise only loopback IP addresses in the 172.16.0.0/24 subnet into your EBGP IP fabric. In this scenario, which two solutions would accomplish this task? (Choose two.) A)
B)
C)
D)
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: D
NEW QUESTION # 67
Exhibit.
Referring to the exhibit, you have a data center in which only the spine devices are using EVPN and VXLAN.
The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.
In this scenario, which command configured on which nodes would solve this problem?
- A. the set protocols evpn no-core-isolation command on the spine nodes
- B. the set protocols evpn no-core-isolation command on the leaf nodes
- C. the disable protocols evpn no-core-isolation command on the spine nodes
- D. the disable protocols evpn no-core-isolation command on the leaf nodes
Answer: A
NEW QUESTION # 68
You have configured a new MC-LAG connection to a host. After committing the configuration, the MC-LAG
link is not functioning properly.
Referring to the exhibit, how would you solve this problem?
- A. Configure status-control on qfx2 to active
- B. Configure a system-id on qfx1 that is different from the system-id on qfx2
- C. Change the chassis on qfx1 to 1
- D. Change the mc-ae is on qfx1 to 1
Answer: D
NEW QUESTION # 69
You have a two spine and four leaf CRB topology and you must ensure that the hosts connected to the leaf devices have reachability to all IRB interface addresses, including the local spine IRB addresses, and the virtual gateway address.
Which two configuration parameters must be used to accomplish this task? (Choose two.)
- A. Configure proxy-macip-advertisement under the IRB interface.
- B. Configure a spine-to-spine BGP peering as part of the overlay.
- C. Configure a spine-to-spine EVPN peering as part of the routing instance.
- D. Configure virtual-gateway-accept-data under the IRB interface.
Answer: A,D
NEW QUESTION # 70
Exhibit.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The remote leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.
- B. The local leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.
- C. The remote leaf is using the 192.168.100.101 IP address as the local anchor point of the VTEP tunnel.
- D. The local leaf is using the 192.168.100.102 IP address as the local anchor point of the VTEP tunnel.
Answer: C,D
NEW QUESTION # 71
You are asked to deploy an Ethernet bridging design in a data center with the criteria shown below.
-- Routing must occur on the spine devices.
- VTEPs must terminate on the leaf devices.
- Facilitate inter-VLAN communication.
-- Layer 2 gateways must be present on spine and leaf devices.
Which architecture should you use in this scenario?
- A. edge-routed bridging architecture
- B. bridge overlay architecture
- C. centrally-routed bridging architecture
- D. collapsed spine architecture
Answer: D
NEW QUESTION # 72
Which two statements are correct about VXLANs? (Choose two.)
- A. VXLANs have a smaller logical network identifier than VLANs.
- B. VXLANs have smaller broadcast domains than VLANs.
- C. VXLANs are an overlay technology.
- D. VXLANs can have a theoretical maximum of 16 million unique networks.
Answer: C,D
NEW QUESTION # 73
You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
--routing must occur on the leaf devices.
--VTEPs must terminate on the leaf devices.
--facilitate inter-VLAN communication, -- lower latency with East-West traffic.
Which architecture should you use in this scenario?
- A. bridge overlay architecture
- B. centrally-routed bridging architecture
- C. collapsed spine architecture
- D. edge-routed bridging architecture
Answer: D
NEW QUESTION # 74
Referring to the VTEP output shown in the exhibit, which two statements are true? (Choose two.)
- A. The MAC address 52:54:00 2c 4b:a2 belongs to a local host.
- B. The. MAC address 52:54:00 5e 88 6a belongs to a remote host.
- C. The MAC address 52:54:00 2c 4b:a2 belongs to a remote host.
- D. The MAC address 52:54;00 5e 88 6a belongs to a local host.
Answer: B,C
NEW QUESTION # 75
You are an engineer for a hosting company. You have a new customer that wants the ability to connect any VLAN on any port. They want to have all VLANs map to a single bridge domain and EVPN instance (EVI). They control all their own routing and just need the connectivity.
Which two parameters should you configure to achieve these goals? (Choose two.)
- A. service-type vlan-bundle
- B. service-type vlan-aware
- C. instance-type mac-vrf
- D. instance-type virtual-switch
Answer: C,D
NEW QUESTION # 76
Which two combinations are supported when configuring a Virtual Chassis Fabric? (Choose two.)
- A. Two spine and 28 leaf nodes
- B. two spine nods and 16 leaf nodes
- C. Four spine nods with 16 leaf nodes
- D. Four spine nods and 20 leaf nodes
Answer: B,C
NEW QUESTION # 77
You are asked to design a deployment plan for a large number of QFX Series switches using ZTP. The ZTP
deployment plan must ensure all switches are configured with their designated configuration file.
Which DHCP option and subscription combination would be used to accomplish this task?
- A. DHCP option 66 a suboption of 00.
- B. DHCP option 66 a suboption of 01.
- C. DHCP option 43 a suboption of 00.
- D. DHCP option 43 a suboption of 01.
Answer: D
NEW QUESTION # 78
You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)
- A. Configuring both IRB interfaces manually with the same address
- B. Allowing Junos to dynamically create the virtual IP address of the IRB interface
- C. Configuring both IRB interfaces manually with the same IP address
- D. Allowing Junos to dynamically create the virtual MAC address of the IRB interface
Answer: B,C
NEW QUESTION # 79
You are designing a Layer 3 fabric underlay using EBGP. You will implement an E VPN-signaled VXLAN overlay on the Layer 3 fabric.
In this scenario, what must you do in the underlay to ensure that the VXLAN overlay will be able to function properly?
- A. Each device in the underlay should advertise its loopback address
- B. The underlay should be configured with a separate VRF tor each potential tenant
- C. The underlay should advertise the host connected interlaces on all leaf device
- D. The underlay should support the PIM protocol
Answer: A
NEW QUESTION # 80
Exhibit.
An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network, \
and device leaf1 has been elected as the designated forwarder.In this scenario, which statement is true?
- A. An ICCP control link must be configured between leaf1 and Ieaf2.
- B. Broadcast packets sent from host2 will not be forwarded to Ieaf2.
- C. The Ieaf3 device will only receive an advertisement to the LAG segment from leaf1.
- D. The Ieaf3 device can utilize both leaf1 and Ieaf2 to forward unicast packets from host2 to host1.
Answer: C
NEW QUESTION # 81
Which two characteristics would you consider when selecting spine devices in an IP fabric?
(Choose two.)
- A. data center location
- B. port density
- C. spanning tree limitations
- D. scaling limitations
Answer: A,C
NEW QUESTION # 82
What are two streaming data formats supported for network analytics? (Choose two.)
- A. XML
- B. SLAX
- C. GPB
- D. JSON
Answer: C,D
Explanation:
Explanation
Starting in Junos OS Release 13.2X51-D15, network analytics supports the following streaming data formats and output:
* Google Protocol Buffer (GPB)
* JavaScript Object Notation (JSON)
* Comma-separated Values (CSV)
* Tab-separated Values (TSV)
* Queue Statistics Output for JSON, CSV, and TSV
* Traffic Statistics Output for JSON, CSV, and TSV
https://www.juniper.net/documentation/us/en/software/junos/network-mgmt/topics/topic-map/network-analytics.
NEW QUESTION # 83
Exhibit.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The irb. 0 interface is the remote tunnel endpoint interface.
- B. There are two tunnels to the remote endpoint.
- C. The source tunnel IP address is 192.168.100.11.
- D. There is one tunnel to the remote endpoint.
Answer: B
NEW QUESTION # 84
Host1 and host2 are connected to an EVPN signaled VXLAN overlay, and must have Layer 3 connectivity.
The VNI and VLAN assignments are shown in the exhibit.
In this scenario, which two statements are true? (Choose two.)
- A. The ESI assigned to the host1 link will be different from the ESI assigned to the host link.
- B. The VNI assigned to the host1 link must be same as the VNI assigned to the host2 link.
- C. A Layer 3 gateway can be configured on the leaf devices.
- D. A layer 3 gateway can be configured on the spine devices.
Answer: C,D
NEW QUESTION # 85
......
Juniper JN0-682 certification exam is a valuable credential for IT professionals who are looking to advance their careers in data center networking. JN0-682 exam validates the candidate's skills and knowledge in designing, configuring, implementing, and troubleshooting complex data center environments using Juniper Networks products and solutions. With this certification, candidates can demonstrate their expertise in Juniper Networks technologies and gain a competitive advantage in the job market.
JN0-682 certification guide Q&A from Training Expert DumpStillValid: https://www.dumpstillvalid.com/JN0-682-prep4sure-review.html
The Best JNCIP-DC Study Guide for the JN0-682 Exam: https://drive.google.com/open?id=1QkvJS2YCIcY0lxrY-_ikxfhD1hVjinEB
